膩子粉經常出現的問題和預防方法！

來源：http://www.zzmdwxsh.com 日期：2019-05-13 發布人：

　　膩子打磨粗

　　Putty polished roughly

　　現象：膩子批刮成活后，打磨砂痕粗。

　　Phenomenon: After the putty is scraped alive in batches, the abrasive marks are rough.

　　緣由：1、磨料太粗。

　　Reasons: 1. Abrasives are too coarse.

　　2、膩子被混入其它物質。

　　2. Putty is mixed with other substances.

　　3、膩子未干。

　　3. Putty is not dry.

　　4、耐水膩子枯燥太快，保濕時間短，未到達正常粘結強度。

　　4. Water-resistant putty is too dry and fast, and its moisturizing time is too short to reach the normal bonding strength.

　　預防：1、選用360#--600#砂紙砂磨.。

　　Prevention: 1. Choose 360 # - 600 # sandpaper grinding.

　　2、膩子分配時只需加水.。

　　2. When putty is distributed, only water is needed.

　　3、砂磨時,膩子應干到八成以上。

　　3. When sanding, putty should be dried up to more than 80%.

　　4、施工時應依據環境氣候適度控制膩子的枯燥時間。

　　4. The dry time of putty should be moderately controlled according to the environment and climate during construction.

　　整改：用較細砂紙修磨或上過底漆后用底漆配滑石粉刮補。

　　Rectification: grinding with fine sandpaper or scraping with primer and talc powder.

　　顏色不一

　　Different colors

　　現象：膩子施工后，外表有色差或色斑。

　　Phenomenon: After putty construction, there are color differences or spots on the surface.

　　緣由：1、運用了不同型號或批次的產品會有細微色差。

　　Reasons: 1. Products of different models or batches will have slight color difference.

　　2、基層未處置好，滲色。

　　2. The grass-roots units are not disposed of properly and seepage.

　　3、膩子中混入其它物質，配比或攪拌不平均。

　　3. Putty mixed with other substances, the mixing ratio or stirring is uneven.

　　4、被污染，如噴漆，滲水，油煙等。

　　4. Contaminated, such as spray paint, water seepage, soot, etc.

　　預防：1、壓光膩子表層應選用同型號同批次產品。

　　Prevention: 1. Calendering putty surface should choose the same model and batch products.

　　2、對基層污漬必需肅清或封鎖處置，接縫王要待干透后刷耐黃變封鎖底漆。暴露金屬要做防銹處置。

　　2. The base stains must be cleaned up or blocked. The seam king should brush the yellowing resistant blocking primer after drying out. Exposure to metal should be treated with rust prevention.

　　3、施工時要留意現場防護。

　　3. Attention should be paid to site protection during construction.

　　整改：1. 膩子資料色差上過涂料后即可消弭。

　　Correction: 1. Putty material color difference can be eliminated after coating.

　　2. 污染性色差需肅清污染源并對受污染基層做封鎖處置。

　　2. Pollutant color difference needs to be cleaned up and blocked at the polluted grass-roots level.

上一篇：抹面砂漿出現這三類問題應該怎么辦？
下一篇：膩子粉經使用過程中有哪些錯誤的操作？

相關推薦：
• 
  濟南抹面砂漿：墻面規整的“幕后功臣”，施工要點全解析
• 
  濟南自建房必看：抹面砂漿灑水養護不是小事，規范施工才耐用
• 
  油工師傅必看！濟南膩子粉干燥過快？這幾個方法輕松解決
• 
  濟南抹面砂漿強度怎么選？關鍵看場景適配
• 
  濟南膩子粉使用不翻車！調制 + 施工全流程技巧大揭秘
• 
  抗裂砂漿無法取代的建筑基石 —— 濟南水泥砂漿科普
• 
  沒用完的膩子粉別浪費！這樣保存，下次施工還能用
• 
  新房裝修避坑，選擇環保合規的濟南膩子粉需要看這三點