1、 The cost difference is not big, but the thickness of thin layer masonry mortar mortar joint is about 1 / 3 of the traditional one, which not only saves materials. It is more in line with the national general direction of improving building energy efficiency and building a conservation oriented society.

二、質量對比

2、 Quality comparison

薄層砌筑砂漿，保水好，砌塊可以不用灑水。

Thin layer masonry mortar, good water retention, block can not spray water.

三、施工方式

3、 Construction method

普通砌筑砂漿：基材表面的雜質清理，磚塊施工前必須灑水；砌筑時應上下錯縫，施工厚度在15-20mm。

Common masonry mortar: the impurities on the surface of the base material shall be cleaned, and the bricks shall be watered before construction; The masonry should be staggered up and down, and the construction thickness should be 15-20 mm.

薄層砌筑砂漿：基材表面的雜質清理，磚塊施工前無須灑水；砌筑時應上下錯縫，施工厚度在3-5mm。

Thin layer masonry mortar: the impurities on the surface of the base material shall be cleaned, and there is no need to spray water before the brick construction; The masonry should be staggered up and down, and the construction thickness should be 3-5mm.

薄層砌筑砂漿

Thin layer masonry mortar

四、結論分析

4、 Conclusion analysis

普通砂漿一般都是攪拌站運輸?shù)焦さ睾笫褂茫３?huì)有因?yàn)樗惴讲粶?zhǔn)或者因?yàn)槭┕ぢ斐蓵?huì)剩下一定的尾漿，由于監管不到位，很多尾漿私自用于施工。這些尾漿很容易對工程質量造成危害。

Ordinary mortar is generally used after the mixing station is transported to the construction site. Due to the inaccurate calculation or slow construction, there is a certain amount of tail slurry left. Due to the lack of supervision, many tail slurry is used for construction privately. These tailing slurries are easy to cause harm to the engineering quality.

而薄層砌筑砂漿完全是由工地工人自己加水?dāng)嚢枋┕さ模龆嗌儆枚嗌伲梢酝耆沤^尾漿的使用。其使用簡單，施工速度快，而且施工質量也有一個較大保證。

The thin layer masonry mortar is completely mixed with water by the workers on the construction site, so the use of tail slurry can be completely eliminated. Its use is simple, construction speed is fast, and construction quality also has a big guarantee.