一、膩?zhàn)由弦粚臃?/div>
1. A layer of powder on the putty
落粉原因:
Reasons for flour drop:
1. 膩?zhàn)臃鄣呐谱硬粔蚝谩D佔臃鄣膾伖鈺r(shí)間不夠好。
1. Putty powder is not good enough. The polishing time of putty powder is not good enough.
2. 產品超過保質期,粘接強度大大降低。
2. When the product exceeds the shelf life, the bonding strength decreases greatly.
3、產品貯存不當,吸濕后粘接力明顯減少。
3. The adhesive force of the product decreased obviously after hygroscopicity due to improper storage.
4、基材吸水率高,導致膩?zhàn)痈稍锼俣瓤欤瑳](méi)有足夠的水進行固化。
4. The high water absorption of the base material results in the fast drying speed of putty and insufficient water for curing.
滴粉溶液:
Dropping powder solution:
1、內墻膩?zhàn)颖砻鎸訏伖庖莆蘸线m的拋光時間,拋光的佳時間是等待膩?zhàn)颖砻嫠∠Ш螅⒓磼伖狻?/div>
1. Proper polishing time should be mastered in polishing the surface layer of putty on the inner wall. The best polishing time is to wait for the putty surface watermarking to disappear and polish immediately.
膩?zhàn)臃?/div>
Putty powder
2. 產品必須在保質期內使用。如果超過保質期,必須進行測試和刮擦。在建設。
2. Products must be used within the shelf life. If it exceeds the shelf life, it must be tested and scraped. Construction is under way.
3、產品必須注意防水,應放在陰涼干燥處,并確保包裝完好。
3. The product must be waterproof, should be placed in a cool and dry place, and ensure that the packaging is in good condition.
![濟南膩?zhàn)臃? src=]()
4、夏季或高溫氣候條件下,敷吹風機膩?zhàn)忧昂孟扔们逅疂駶?rùn)墻面,墻面表面沒有清水后,可敷吹風機膩?zhàn)印?/div>
4. In summer or high temperature climatic conditions, it is better to wet the wall with clear water before applying the putty. If there is no clear water on the wall surface, the putty can be applied.
5、購買知名膩?zhàn)臃燮放啤?/div>
5. Buy well-known putty powder brand.
2. 膩?zhàn)訉幼凕S了
2. Putty layer yellows
1、與聚酯漆(涂料)或脫模劑同時使用,造成膩?zhàn)幽ぐl(fā)黃。
1. Use with polyester paint (paint) or release agent at the same time, resulting in putty film yellowing.
2、底座有油脂或其他油脂污垢,未清理干凈,導致膩?zhàn)幽ぐl(fā)黃。
2. There is grease or other grease dirt on the base, which is not cleaned up, resulting in yellowing of putty membrane.
3.膩?zhàn)幽な茕P蝕或其它死物料污染,可能導致膩?zhàn)幽ぐl(fā)黃。
3. Putty membranes are contaminated by rust or other dead materials, which may cause putty membranes to yellowish.
4. 膩?zhàn)臃鄣钠放啤?/div>
4. Putty powder brand.
泛黃的解決方案:
Solutions to yellowing:
避免與聚酯漆(漆)或脫模劑同時使用。
Avoid using with polyester paint or release agent.
2. 底座應清洗干凈,避免油漬。
2. The base should be cleaned to avoid oil stains.
3、膩?zhàn)邮┕ず螅⒁獬善返谋Wo(hù),避免污染。
3. After putty construction, pay attention to the protection of finished products to avoid pollution.
4. 施工溫度不宜過低或低于5度。
4. Construction temperature should not be too low or below 5 degrees.
5、購買有保證的膩?zhàn)臃燮放啤?/div>
5. Buy guaranteed putty powder brand.
???
主站蜘蛛池模板:
中文成人无字幕乱码精品|
少妇人妻诗雨1一一12|
日韩一区二区三区水蜜桃|
亚洲VA欧美VA国产综合|
色综合天天综合网中文|
2020国产精品久久精品|
麻豆久久久9性大片|
日本免费视频色www|
无码人妻久久一区二区三区蜜桃|
国产一区三区二区中文在线|
亚洲免费无码三级片|
国产99视频精品免费视看6|
欧美激情 亚洲 在线|
久久这里只有精品8|
久久国产精品人妻一区二区|
九九热在线免费精品视频|
亚洲av成人久久18禁|
成年人视频一区二区|
国产精品视频导航|
影音先锋女人AV鲁色资源网久久|
8天堂资源在线|
亚洲国产成人久久久网站|
骚片av蜜桃精品一区|
久久96热在精品国产高清|
欧美午夜在线观看|
一本一道波多野结衣av黑人在线|
蜜桃成熟电影|
奇米精品一区二区三区在线观看|
国产香蕉97碰碰视频碰碰看|
日本添下边视频全过程|
中文字幕在线视频免费观看|
在线观看免费视频网站A站|
国产精品久久久久久影视|
免费人成视频x8x8国产|
视频一区视频二区制服丝袜|
国产欧美专区在线观看|
91人妻无码成人精品一区91|
天天躁夜夜躁狠狠喷水|
美腿丝袜一区二区三区|
久久无码专区国产精品s|
亚洲AV无码成H人动漫无遮挡|